How to Use Eyedrops
- Wash your hands thoroughly with soap and water.
- Check the dropper tip to make sure that it is not chipped or cracked.
- Avoid touching the dropper tip against your eye or anything else; eyedrops and dropper must be kept clean.
- Remove contact lenses unless the product is to be specifically used with contact lenses.
- While tilting your head back, pull down the lower lid of your eye with your index finger to form a pocket (see figure).
- Hold the dropper (tip down) with the other hand, as close to the eye as possible without touching it.
- Brace the remaining fingers of that hand against your face.
- While looking up, gently squeeze the dropper so that a single drop falls into the pocket made by the lower eyelid. Remove your index finger from the lower eyelid.
- Close your eye for 2 to 3 minutes and tip your head down as though looking at the floor. Try not to blink or squeeze your eyelids.
- Place a finger on the tear duct and apply gentle pressure.
- Wipe any excess liquid from your face with a tissue.
- If you are to use more than one drop in the same eye, wait at least 5 minutes before instilling the next drop.
- Replace and tighten the cap on the dropper bottle. Do not wipe or rinse the dropper tip.
- Wash your hands to remove any medication.
Adapted, with permission, from the Michigan Pharmacists Association'sPatient Education Program. Illustration reproduced, with permission, from the Atlas of Primary Eyecare Procedures, Appleton Lange, Norwalk, CT, 1997.
Use the exact number of drops recommended
AHFS® Consumer Medication Information. © Copyright, The American Society of Health-System Pharmacists, Inc., 7272 Wisconsin Avenue, Bethesda, Maryland. All Rights Reserved. Duplication for commercial use must be authorized by ASHP.
Last Reviewed: September 1, 2010.